Specifier Sheet Comprehensive Plant Inoculant, Fertilizer, and Biofertilizer

Mycor™ Plant Saver®: Mycor™ Plant Saver®: is a comprehensive fertility product used in planting or maintaining most plants. It contains a blend of spores of VA mycorrhizal (VAM) fungi and ectomycorrhizal fungi, beneficial rhizosphere bacteria, 4-7-4 fertilizer, organic amendments, and a comprehensive selection of micronutrients designed to address the mineral deficiencies common to many plants. 

Product Specification
GUARANTEED NUTRIENT ANALYSIS 4-7-4

Total Nitrogen (N)....................................................4%
1% water Soluble Nitrogen   
3% Water Insoluble Nitrogen
Available Phosphate (P₂O₅).....................................7%
Soluble Potash (K₂O)..............................................4%

Iron (Fe)..............................3%                          Manganese (Mn)..............................0.7%
          0.03% Water soluble Iron (Fe)                              0.1% Water soluble Manganese (Mn)
Magnesium (Mg)..............................3%              Zinc (Zn)..............................0.4%
          0.07% Water soluble Magnesium (Mg)                  0.03% Water soluble Zinc (Zn)
Boron (B)..............................0.2%
          0.2% Water soluble Boron (B)

Derived from: Ureaform, Calcium phosphate, Bone Meal, Blood Meal, Kelp Meal, Feather Meal, Sulfate of potash, Dolomitic limestone, Iron sucrate, Magnesium sucrate, Manganese sucrate, Zinc sucrate, Sodium tetraborate.

NON PLANT FOOD INGREDIENTS
Humic acids..............................7% 

VA mycorrhizal (VAM) Fungi......................................................................1024 spores*/Lb
          Glomus clarum........................256 spores*/Lb 
          Glomus etunicatum..................256 spores*/Lb 
          Glomus intraradices.................256 spores*/Lb 
          Entrophospora columbiana.......256 spores*/Lb 

Ectomycorrhizal fungus (Pisolithus tinctorius).....................................13. 5 Million spores/Lb
*Fungal counts represent only spores, and do not refer to root fragments or other nonspore propagules.

Rhizosphere Bacteria.................................................................................80 Million cfu/Lb
          13.33 Million cfu/Lb Bacillus licheniformis      13.33 Million cfu/Lb Bacillus subtilis
          13.33 Million cfu/Lb Bacillus megaterium       13.33 Million cfu/Lb Bacillus thuringiensis
          13.33 Million cfu/Lb Bacillus polymyxa           13.33 Million cfu/Lb Paenibacillus azotofixans

Directions: 
Established Trees and Shrubs: Use a 2 ½ inch wide earth auger to drill product into the soil at a rate of 4-oz. per hole, so that product is thoroughly mixed with the soil. The following procedure is recommended: (1) Remove mulch. (2) Place 4-oz MycorTree® Vertimulch directly over point to be drilled. (3) Drill directly through the 4-oz pile of product, to a depth of 8 inches. (4) Drill up and down 2 or 3 times to mix product. (5) Remove drill from hole. (6) Return all loose soil back into hole. (7) Step with foot to pack. (8) Replace mulch. (9) Proceed to next hole. Continue drilling numerous such holes to cover the entire area beneath the canopy, from the trunk outward to slightly beyond the drip line, following a grid pattern with approximately 2½-foot spacing. Two hundred (200) holes at this spacing will cover about 1250 square feet, equivalent to the area beneath a 40-ft diameter canopy.

New Plantings: Thoroughly mix product into backfill at a rate of about 8-oz (2 scoops) of Plant Saver for each foot diameter of the planting hole. For small plants or bulbs, add 1 tablespoon ( ½ oz or 15 cc) per plant, and mix thoroughly with soil in the planting hole.

Proof of Compliance with Specifications: The contractor will demonstrate compliance by showing invoices to prove purchase of product in sufficient quantity to cover the project at the rates recommended by the manufacturer. Include project name, date of purchase of product, and name of contact.